Free Shipping On Orders over $250*
$19.99
In Stock
Sold out
Add to wishlist
Added to wishlist
Add to compare
Added to compare
Diode Dynamics
Limited Lifetime Warranty
- Description
- Install Guide
- Reviews
- Questions & Answers
TheYotaGarage is proud to offer the Diode Dynamics LED Resistor Kit for universal fitment.
Features:
- Prevent Hyperblinking
- 6" Leads For Easy Install
- 50 Watt Rating
- 6 OHM
- Includes everything needed for installation.
-
We recommend one resistor per turn signal bulb that is switched to LED. If you are installing both front and rear turn signal bulbs, we recommend four total resistors.
-
This is a universal product and can be installed on any vehicle.
Includes:
- Two (2) resistors
- Four (4) quick-splice "scotch-lock" connectors
NOTE: Resistors will be hot to the touch when the turn signal is activated for a prolonged period of time. This is normal operation. We recommend mounting the resistors away from any plastic, wires, or fabric.
Prevent Hyperblinking. When you replace incandescent turn signal bulbs with LEDs in most vehicles, the vehicle will start hyperblinking. This is because the LED uses much less power, and the vehicle thinks the bulb is out. You can easily fix this problem by installing resistors.
To install, connect one side of the resistor to the positive turn signal wire, and the other side to negative (ground) with included connectors. To determine which wires to tap on a dual filament socket, we recommend using a voltmeter to test the two power wires. Simply engage your turn signal on the side you're installing the resistor, touch your voltmeter probe to each pin inside of the socket, and the pin that gives a voltage readout is the power wire that needs to be tapped. Typically the ground wire is a black wire. Each resistor has 6" leads for easier installation, and has a rating of 50 watts, 6ohm. This is usually enough to compensate for one bulb. If you are installing four LED turn signals (front and rear), we recommend four total resistors.